View Single Post
Old July 2, 2018, 01:58 PM   #10
Senior Member
Join Date: June 23, 2013
Location: Central Pennsyltucky...
Posts: 1,909
I'm essentially stuck with having to machine a piece of brass to make my casing. Extremely hard to find, and extremely expensive.

With the rebated rim,(the original casing was only using 40k psi) I'm looking to hopefully keep it from expanding into the extractor groove.

I was thinking of shot peening my material first, machining, then annealing the neck/shoulder area to form them.

My apologies for the confusion.
I am in earnest- I will not equivocate- I will not excuse-
I will not retreat a single inch- AND I WILL BE HEARD!
William Lloyd Garrison - The Liberator 1831
std7mag is offline  
Page generated in 0.02915 seconds with 8 queries