View Single Post
Old February 26, 2009, 10:52 AM   #26
zxcvbob
Senior Member
 
Join Date: December 20, 2007
Location: S.E. Minnesota
Posts: 4,539
Quote:
Can't you just drill the crimp with the right size bit? I was thinking of doing this with some S&B 38spl brass I have.
I'm going to try that with a 60° countersink bit -- when I find my countersink. But I think it may take a little more than that; maybe chamfer with a countersink and then open up the pockets with a Hornady pocket reamer.
Quote:
Anybody happen to notice that this thread is like 4 months old until today?
Yes, I saw that when I bumped it up again. It seemed more appropriate than starting a new one.
__________________
"Everything they do is so dramatic and flamboyant. It just makes me want to set myself on fire!" —Lucille Bluth
zxcvbob is offline  
 
Page generated in 0.02770 seconds with 8 queries