View Single Post
Old May 21, 2019, 09:30 PM   #8
Senior Member
Join Date: February 26, 2013
Location: on the lam
Posts: 1,484
Not sure why it would require any trigger work, or polishing of the feed ramp.
If you cue up the video in the OP to 4:20 you'll see the trigger bar and a spring. He was addressing the squeak. Mine made a little noise, but the main problem was the little spring would snag in several spots along the bottom of the trigger bar as it was dragged across it. The smoothing of the trigger bar made the trigger pull much smoother, and quieter.

As far as polishing the feed ramp, I've had a tube of Simichrome for years and figured I might as well use it.

Last edited by Carmady; May 21, 2019 at 09:35 PM.
Carmady is offline  
Page generated in 0.03050 seconds with 8 queries