View Single Post
Old December 5, 2018, 07:23 PM   #6
Hammerhead
Senior Member
 
Join Date: May 31, 2004
Location: Minnesota
Posts: 2,248
BTW, I don't think that's a crimp groove, I guess it's a pseudo lube groove. For light loads a light roll crimp into the side of the bullet should be fine.

My Speer #10 recommends seating them deep and roll crimping over the shoulder. I'm sure that's just the ticket for full power stuff, but I never liked that method with SWC's.

For target loads and swaged bullets of most brands and calibers I just lightly roll or profile crimp into the side of the bullet where I want it.
Hammerhead is offline  
 
Page generated in 0.03140 seconds with 8 queries