It is certainly a question of how hard the hammer hits the primer area.
I had it out today, and some rounds took 4-5 hits in the same area before detonating. Some went off the first strike. The spring looks a little oxidized, so maybe that is just the problem.
So is the the part I am calling the "mainspring," the part that goes through the grip and has a guide rod that goes through a hole lower in the frame, and a sort of Y shaped rocker towards the top that rides against the hammer? In this model it is a coil, I have seen a few with a leaf-type spring in there, but this is a coil with a guide rod. Everything else seems to be working ok.. timing, where it hits, how it locks, so on and so forth. So I hope it is not a lost cause that will be turned into a gun buyback for a $50 gas card (although I could use one). But a .22 revolver is something I would like to have.
If that is all I need to change, would be nice to get it operational for fun.
It works well when it works..
matt
|