View Single Post
Old February 25, 2007, 04:16 PM   #1
ShootingNut
Senior Member
 
Join Date: December 27, 2006
Location: Wisconsin
Posts: 1,475
Checking Primer pocket

Somewhere I read, one should always check the primer pocket for any crud, and scrape it out with a flat screwdriver or tool. When using a Turret press, or a Progressive Press, who pulls the casing out after the die has punched out the old primer, to inspect and scrape if needed?
Or, is this suggestion for a single stage press operation? I'm new, still learning!
Thanks!
ShootingNut is offline  
 
Page generated in 0.05171 seconds with 8 queries