The Firing Line Forums - View Single Post - Scale accuracy and precision, how much is needed?

hounddawg · January 15, 2019, 04:37 PM

Some electronics are sensitive to temp it seems. I have one that goes berserk if the temperature in the shop drops below 60F. Even after heating the place up it takes a few hours to stabilize. Two others no problem at least down to 50F and of course my Lyman beam could care less if it was sub zero

I think the biggest contributor to consistent velocities is the powder choice for not only the cartridge but also the barrel. Find the right one and you can load with a rotary throw and be good enough. Maybe we need a thread on that

January 15, 2019, 04:37 PM	#8
hounddawg Senior Member Join Date: March 1, 2009 Posts: 4,232	Some electronics are sensitive to temp it seems. I have one that goes berserk if the temperature in the shop drops below 60F. Even after heating the place up it takes a few hours to stabilize. Two others no problem at least down to 50F and of course my Lyman beam could care less if it was sub zero I think the biggest contributor to consistent velocities is the powder choice for not only the cartridge but also the barrel. Find the right one and you can load with a rotary throw and be good enough. Maybe we need a thread on that __________________ “How do I get to the next level?” Well, you get to the next level by being the first one on the range and the last one to leave.” – Jerry Miculek