View Single Post
Old February 14, 2013, 01:03 PM   #12
Sevens
Senior Member
 
Join Date: July 28, 2007
Location: Ohio
Posts: 11,753
Quote:
The Cylinder Std was replaced with a much improved design.
It certainly is different looking -- but how is it improved or better for the end user? I've read that it streamlines manufacturing because it's part of the frame and not a part that must be put in to place. Should we assume that because of that...it "strengthens" the frame in some manner?

I suppose I am saying: of all the different quirks any S&W revolver has ever had over the century... I don't recall the old traditional cylinder stop being one of them.
__________________
Attention Brass rats and other reloaders: I really need .327 Federal Magnum brass, no lot size too small. Tell me what caliber you need and I'll see what I have to swap. PM me and we'll discuss.
Sevens is offline  
 
Page generated in 0.02166 seconds with 8 queries