Thread: mixing powder.
View Single Post
Old January 29, 2012, 09:24 AM   #12
Senior Member
Join Date: November 22, 2006
Posts: 2,895
If the load is up near max it might be an issue.
Good point, I don't load any caliber at max but I have enough guns I can just go get the next bigger one.

So, if you are loading close enough to the edge that you adjust you measure down to smaller charges and work back up the load again every time you hit the end of a powder container, I wouldn't mix the last little bit. If you are leaving the measure where it was, I don't see any point.
jmorris is offline  
Page generated in 0.03296 seconds with 8 queries