I've been following this thread with some interest. I am a new caster and I went the route of TL bullets. I cast for plinking, so I haven't made it to the point that I buy more expensive molds (moulds) for super-accuracy.
I've tried cast-lube-load, cast-lube-size-load, cast-lube-size-lube-load, and cast-size-lube-load. I can't tell any difference in the shooting, other than if I put sizing somewhere in the mix, the bullet seating seems to go better.
Last edited by Shane Tuttle; August 21, 2011 at 08:10 AM.
Reason: Bullets...
|