View Single Post
Old April 28, 2012, 09:32 PM   #52
us2jmp
Junior Member
 
Join Date: April 28, 2012
Posts: 1
ruger lc9 extractor

the comments regarding the ruger lc9 extractor & extractor spring problems have been very helpful. today, i was inserting a loaded magazine in my lc9, as i released the slide assembly to chamber a round...pieces flew off of my gun. after examining what the problem was, i noticed the extractor, extractor spring, and pin were all missing! fortunately i found the spring & extractor. uncertain as to why this happened and what to do - I searched the web and found these threads regarding the same issues. I will contact ruger asap and hope they remedy this on-going weapon failure! thanks again for the help.
us2jmp is offline  
 
Page generated in 0.04304 seconds with 8 queries