View Single Post
Old November 12, 2012, 04:40 PM   #25
max it
Senior Member
 
Join Date: June 15, 2008
Location: SoCal; are we done yet?
Posts: 272
Hi Ya, I resluged the barrel of my XD and found it still .355"
but the bullseye load is still keyholing; this time i used the moly coate 147gn with 3.2gn bullseye 1.058" oal. and for good measure I loaded some 130gn truncated cone moly coated .358" called .38cal bullets together with 3.6gn of Bullseye seated at 1.10"oal just for fun.
The first one, keyholed at 20 yards and beyond. the second one was no more accurate which is about 10" spread at 23 yards, so no brass ring there either.
I think I am going to take Gerry's wized advise and go back to the begining; Red Dot. Before I do that I will try the bullseye with some Copper plated 147gn I bought.
Much obliged,

Max
p.s. did the 3.6gn Bullseye, plated 147gn seems better. I will go with it for the competition on Sunday. Let's see if it knocks down some steel.

MI

Last edited by max it; November 14, 2012 at 04:00 PM.
max it is offline  
 
Page generated in 0.03707 seconds with 8 queries