[MEATSAW]

I'm not nearby the press so I'll do my best to describe what I did. I took a piece of 3/4" plywood and cut it in a rectangle (probably 8" x 5"). I did this so I could mount the press to this piece and allow a bit of overhang off my bench. I then bored out two holes directly underneath where the primers fall. Once this was complete I screwed n glued the plywood piece to the bench, and then mounted the press to the plywood piece. I then used two pieces of old fuel line and reamed out the inner diameter a bit. They fit snugly in the two holes in the plywood. Directly under the press I put a small kitchen garbage can. During use all the primers that go underneath the press find themselves in the garbage can. If you go slow when de-priming they tend to all go there instead of flying every which way. You will still get a few fliers but hell, nothing perfect!