The "good" thing about DIY bedding is as long as a few basic tenets are followed, you can't do any real harm...
Plenty of release agent
Putty wherever you don't want epoxy
No reverse angles
Tape up the stock!
The most common mistake by beginners (including my first attempts) was to skimp on epoxy...use plenty of it, let it ooze out everywhere. Easy clean up when done correctly (wait until it just begins to set- then it will easily peel up, and be cut with a razor knife before it hardens). If there are voids or mistakes, cured epoxy is easily ground out and re-done.
__________________
Remington 700/Savage Rebarreling /Action Blueprinting
07 FFL /Mosin-Nagant Custom Shop/Bent Bolts
Genuine Cerakote Applicator
www.biggorillagunworks.com
|