View Single Post
Old September 2, 2007, 02:38 PM   #2
Unclenick
Staff
 
Join Date: March 4, 2005
Location: Ohio
Posts: 19,301
I've run into this before. I think maybe the accelerator is installed incorrectly? It's a small right angle piece pinned into operating rod catch (the forked piece the elbow of the follower rod rides in; the follower rod is the part the op-rod spring is skewered onto). See if you can borrow the working gun again an pull it out of the its stock alongside yours and look carefully at that part? You'll have to pull the op-rod spring off the follower assembly to get at it.

It's been so long since I ran into that, I would verify it by calling Anniston. The guys in the shop there will answer technical questions and they have the gun memorized inside and out. (256) 835-8455.
__________________
Gunsite Orange Hat Family Member
CMP Certified GSM Master Instructor
NRA Certified Rifle Instructor
NRA Benefactor Member and Golden Eagle
Unclenick is offline  
 
Page generated in 0.02317 seconds with 8 queries