View Single Post
Old June 12, 2019, 12:15 PM   #30
F. Guffey
Senior Member
 
Join Date: July 18, 2008
Posts: 7,257
Quote:
Answering both questions on trimming and shoulder setback . How and when do you trim when using a turret press , I'm only a single stage reloader .
I have more than one turret press and at least 15 single stage presses. I do not have to look up at the press I am using to determine case trimming. I have forming dies, my forming dies are multi taskers, they are trim and forming dies. When I form a case with a forming die I finish it by trimming the case before I lower the ram with a hack saw and finish with a file. There are times I trim with aircraft countersinks; the counter sink give me that smooth bevel on the inside of the neck.

And then there is the Wilson case gage; reloaders can not accept the Wilson case gage as a multi tasking tool; I am beginning to believe reloaders can not multi task.

F. Guffey
F. Guffey is offline  
 
Page generated in 0.02968 seconds with 8 queries