View Single Post
Old April 26, 2002, 08:26 PM   #15
Andrewh
Senior Member
 
Join Date: July 7, 1999
Posts: 966
Guess I got confused. I did find it again, but it is a black powder warning.
In straight walled cases filler wads may be used to reduce the powder charge. This is done by inserting card or Polyethylene wads between the base of the bullet and the powder. Wads should be
sized to the internal diameter of the cartridge case. The loader must be careful to insure that there are no void spaces in the assembled cartridge. NEVER use any other type of filler material. Be careful as loads are reduced. At some point, the bullet will fail to exit the bore.
But there is a warning on another web site
http://www.reloadammo.com/liteload.htm
Andrewh is offline  
 
Page generated in 0.03488 seconds with 8 queries