View Single Post
Old February 13, 2012, 06:16 PM   #6
Mike / Tx
Senior Member
 
Join Date: April 8, 2000
Posts: 1,918
Can't say with handgun bullet, but when I swapped from standard C&C bullets over to Barnes in my rifles I usually dropped the load by at least 2 full grains, and worked back up a little at a time. This was also using the original X and not the later TSX ro similar banded ones.

As for the handgun bullets, yea your right on the money for your concern. As mentioned the OAL differences alone might be the deciding factor.
__________________
LAter,
Mike / TX
Mike / Tx is offline  
 
Page generated in 0.03118 seconds with 8 queries