View Single Post
Old October 5, 2005, 01:02 PM   #55
shaggy
Senior Member
 
Join Date: October 9, 2004
Posts: 1,519
The conversion part is the machinegun. For example, I own several registered sears. Although its only a small part, it is registered as a machinegun and must be transfered as a machinegun. Legally it IS a machinegun. When I install one into the host gun, the sear remains the machinegun, but the host firearm temporarily becomes part of the same machinegun while the sear is installed. (its important to note that installation of a registered part should not involve any permanent physical changes to the host firearm that would permantly render it a machinegun after the registered part was removed)

Capice?
shaggy is offline  
 
Page generated in 0.03024 seconds with 8 queries