The Firing Line Forums - View Single Post - Husqvarna Commercial M96 vs Commercial FN98 in 8x57

Scorch · October 12, 2011, 01:17 AM

Here's the rub with Husqvarna M98 and 1-piece bases:
They use the same length hole spacing as the M96, but an M96 base won't fit because of the large front ring.
Military 98 bases have the proper hole spacing, but since there are no stripper guide lips, there will be a gap under the rear of a one-piece base.
Rear hole spacing is correct if you use a 2-piece base, but base height may be an issue.

So try a few different bases and see what works, but I would bet you will end up with a 2-piece.

October 12, 2011, 01:17 AM	#11
Scorch Senior Member Join Date: February 13, 2006 Location: Washington state Posts: 15,248	Here's the rub with Husqvarna M98 and 1-piece bases: They use the same length hole spacing as the M96, but an M96 base won't fit because of the large front ring. Military 98 bases have the proper hole spacing, but since there are no stripper guide lips, there will be a gap under the rear of a one-piece base. Rear hole spacing is correct if you use a 2-piece base, but base height may be an issue. So try a few different bases and see what works, but I would bet you will end up with a 2-piece. __________________ Never try to educate someone who resists knowledge at all costs. But what do I know? Summit Arms Services