The Firing Line Forums - View Single Post

Dixie Gunsmithing · July 13, 2013, 12:16 PM

Do any on here do anodizing, and if so, I would like to pick your brain.

Do you use plastic or Pyrex glass plating containers?

Do you etch with lye before the plating? Can you tell a difference if not etched?

What dye do you use, commercial or RIT?

Do you use a sealer, or just boiling water to close the pores?

Do you find that so called space-balls do any smidgen of good?

I am redoing my system, and am looking at ways to speed up the process, and what I should buy new.

July 13, 2013, 12:16 PM	#1
Dixie Gunsmithing Moderator Emeritus Join Date: April 27, 2013 Location: Ohio Posts: 1,923	Anodizing Questions Do any on here do anodizing, and if so, I would like to pick your brain. Do you use plastic or Pyrex glass plating containers? Do you etch with lye before the plating? Can you tell a difference if not etched? What dye do you use, commercial or RIT? Do you use a sealer, or just boiling water to close the pores? Do you find that so called space-balls do any smidgen of good? I am redoing my system, and am looking at ways to speed up the process, and what I should buy new. Last edited by Dixie Gunsmithing; July 14, 2013 at 10:55 AM.