View Single Post
Old March 16, 2018, 03:30 PM   #3
CedarGrove357
Member
 
Join Date: September 12, 2016
Posts: 88
Quote:
Originally Posted by T. O'Heir View Post
What you need to do is D&T for a bigger screw. Acraglas and Devcon Plastic Steel are just epoxy with a fibreglass or powdered steel filler.
Problem is the receiver is too small for the rear screw. This shotgun has pins of the same aize whereas the 1100 has a larger rear pin. Id rather mod the saddle mount than the receiver if possible. Not arguing, can certainly drill the receiver, but im of the notion to be able to set the gun back to factory than perm modify it. Id also like to exhaust all other possibilities before doing a mod that may affect the value. Make sense?

Sent from my SM-G955U using Tapatalk
CedarGrove357 is offline  
 
Page generated in 0.03629 seconds with 8 queries