View Single Post
Old March 29, 2019, 05:56 PM   #1
GarandTd
Senior Member
 
Join Date: June 15, 2016
Location: Western PA rainforests
Posts: 1,329
Ruger Mark III 22/45 stiff bolt and bolt stop lever

I replaced the mag disconnect safety with a TandemKross hammer bushing. Now the bolt is getting slowed down by something and the bolt stop lever is very stiff unless I relieve it while holding the bolt back. The gun fires and ejects, but now needs a bump to finish the bolt returning to battery. I can't figure out what's causing the problem. Pistol still shoots accurately.
__________________
22lr, 20 gauge, 8mm Mauser, 35 Remington, 30-06, 5.56x45/223, 9mm, 380acp
GarandTd is offline  
 
Page generated in 0.02829 seconds with 8 queries