The Firing Line Forums - View Single Post - Reloading Room- need suggestions

Contender · October 6, 2000, 10:34 PM

This is a bench built into a basement closet running under a stairway. I ran 2x6's down the sides and lagged them to the studs. A 2x12 was mounted across the front with some 2x6's spanning across to the rear. 1/2" inch plywood was then fastened to the top. Plenty of storage underneath to rear of closet. Rear shelves are mounted back against the sloping ceiling. I've since added much more equipment and components.

Also have added a quick change mount setup for different presses, electric outlet and flourescent light #2. Bench is about 4 ft wide. Hope this gives someone else an idea. Always was a "closet" reloader.

Here is the Photo Link to preserve thread space. http://albums.photopoint.com/j/View?...nce=0&res=high

[This message has been edited by Contender (edited October 07, 2000).]

October 6, 2000, 10:34 PM	#29
Contender Senior Member Join Date: December 10, 1998 Location: NY Posts: 680	This is a bench built into a basement closet running under a stairway. I ran 2x6's down the sides and lagged them to the studs. A 2x12 was mounted across the front with some 2x6's spanning across to the rear. 1/2" inch plywood was then fastened to the top. Plenty of storage underneath to rear of closet. Rear shelves are mounted back against the sloping ceiling. I've since added much more equipment and components. Also have added a quick change mount setup for different presses, electric outlet and flourescent light #2. Bench is about 4 ft wide. Hope this gives someone else an idea. Always was a "closet" reloader. Here is the Photo Link to preserve thread space. http://albums.photopoint.com/j/View?...nce=0&res=high [This message has been edited by Contender (edited October 07, 2000).]