View Single Post
Old September 28, 2000, 07:23 PM   #6
El Rojo
Senior Member
 
Join Date: February 4, 2000
Location: People's Republik of Kalifornia
Posts: 2,057
This is going to be for grain loads between 39-47 grains of IMR 4064 and 4895 for .308. The Dillon measure works fine for the 4895, you just have to be real careful to see if the powder makes it in or not. It is usually pretty darn accurate. I am just wondering if the higher grade RCBS or escpecially the Redding measures are going to work any better than the Dillon measure. I think they might handle that extruded powder better. I don't want to take the manufacturers word for it, I want some real hand on feedback. Thank you for all of your feedback so far. Keep it coming.
El Rojo is offline  
 
Page generated in 0.03260 seconds with 8 queries