View Single Post
Old December 10, 2019, 03:33 PM   #2
Bart B.
Senior Member
 
Join Date: February 15, 2009
Posts: 8,136
Please define "zeroing elevation."

Is it setting scope elevation to the low limit then using rings to obtain boresight to that point so maximum elevation adjustment is possible?

Do you know how to set the E and W adjustments to center the inner tube on the scope main axis? It's not putting them mid point in their physical range.

Note there'll typically be several clicks up above the upper and past the right limit where no change takes place.

You can use shims under the rear Burris XTR ring to get the scope angle to boresight at the elevation lowest setting.

Last edited by Bart B.; December 10, 2019 at 05:39 PM.
Bart B. is offline  
 
Page generated in 0.03106 seconds with 8 queries