View Single Post
Old November 8, 2019, 12:35 AM   #3
Rapidrob
Member
 
Join Date: January 15, 2006
Location: New Mexico
Posts: 46
I too have been using slave pins to align the parts as I'm testing for problems or assembling.
This pistol will only fire in double action and the pull is excessive.
If I remove the main spring all the parts move smoothly and the trigger resets.
I have the time to play with the main spring and the other parts to try to figure out why there is the slight drag preventing the trigger from reseting on it's own.
The pistol does not appear to have been shot much in it long life. The parts show no signs of mechanical wear. The original finish is long gone.
When I fired the pistol the accuracy is very good sending all five shots touching one another into the target. I'd like to get the pistol operating as it should just to shoot the pistol for fun.
Thank you for the reply.
__________________
President NM MILSURPS
Tonkin Gulf Yacht Club
Rapidrob is offline  
 
Page generated in 0.04772 seconds with 8 queries