View Single Post
Old December 19, 2000, 05:31 PM   #3
Rex Feral
Senior Member
 
Join Date: February 27, 2000
Location: Southern NH, USA
Posts: 471
Did you get the screw under the spot where the recoil spring assembly slots into the receiver?

To remove the front lower handguard: field strip the rifle and remove upper handguard/gastube assembly. Under that, toward the front of the lower handguard is a small lever that must be turned through 180deg (point the end toward the muzzle) to remove the lower handguard. After turning the lever, pull the lower handguard toward the muzzle to remove it.

To remove the wood from the upper handguard/gastube: put the square end of the upper handguard/gastube assembly in a vise to prevent it from rotating, grab the wood portion and rotate your hand, the wood will slip right off the gastube.

All the wood removal can be a little difficult the first few times, but it will loosen up eventually.
__________________
Triumph, or else yield to clamour:
Be the anvil or the hammer.
Rex Feral is offline  
 
Page generated in 0.03335 seconds with 8 queries