The Firing Line Forums - View Single Post

jells · March 22, 2011, 09:43 AM

I bought a Winchester Model 1400 Mk II at an auction. Before firing it, I started to take down the gun, starting at the trigger group. It was grody and I decided to take it down completely and it's clean.

I can not find a detailed reference to help me with the safety buttom and the sear assy. The hammer spring is in the slot but the safety may/may not operate. I'm tired of removing/installing the pin through the hammer spring support.

The sear assy took flight while removing the disconnector and I just need to know where the loop at the end of sear spring goes and the orientation of the spring behind the disconnector.

Any help will be appreciated.

March 22, 2011, 09:43 AM	#1
jells Member Join Date: March 21, 2010 Posts: 46	Reassembly Winchester Model 1400 Mk II I bought a Winchester Model 1400 Mk II at an auction. Before firing it, I started to take down the gun, starting at the trigger group. It was grody and I decided to take it down completely and it's clean. I can not find a detailed reference to help me with the safety buttom and the sear assy. The hammer spring is in the slot but the safety may/may not operate. I'm tired of removing/installing the pin through the hammer spring support. The sear assy took flight while removing the disconnector and I just need to know where the loop at the end of sear spring goes and the orientation of the spring behind the disconnector. Any help will be appreciated.