View Single Post
Old June 18, 2013, 03:14 PM   #16
Senior Member
Join Date: September 28, 2008
Posts: 10,447
You mentioned that you use the same throw technique with every load.
And for the rotating cylinder type of measure, that is very important.
It's also important to not go too fast and allow the cylinder to fill properly, each and every time.
Running the handle up and down too quickly can throw off even the expensive, steel measures.
Walt Kelly, alias Pogo, sez:
“Don't take life so serious, son, it ain't nohow permanent.”
g.willikers is offline  
Page generated in 0.03172 seconds with 8 queries