View Single Post
Old August 20, 2008, 12:34 PM   #5
Senior Member
Join Date: February 13, 2006
Location: Washington state
Posts: 13,306
If you were desperate enough, it's possible to reform 11mm Mauser brass to 11mm Gras,
11mm Mauser has a base diameter of .516" vs the Gras base diameter of .544", so that would be a very risky proposition, even loaded with BP. Besides, the rim diameter of the two are too different, so even if you could get the round to fire, it would probably not extract. Even if you are good with a lathe, and you could make a few cases, then you would need dies. Clean it up, hang it on a wall, and smile when you look at it.
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Taylor Machine
Scorch is offline  
Page generated in 0.03133 seconds with 8 queries