View Single Post
Old October 25, 2006, 01:11 PM   #5
Jeanne Riley
Junior Member
 
Join Date: May 9, 2006
Posts: 12
RS Press RCBS

I was going through the threads and found this one. I know it's old but perhaps someone might still be interested. The RS press was manufactured from 1979 to 1983. It was formally called the Junior. It is cast iron and has a 3" operating window. The dies are screwed directly into the casting so there isn't an RC bushing to allow for a progressive to mount on top. The RS 2 and 3 came later, 1982 -1990. The RS2 and 3 are cast aluminum. The 2 did not have a bushing but the 3 did. If you have an RS3 you can mount a Piggyback 2 or Piggyback 3 on top. They both used a Ram Priming unit while the RS series used the Universal Priming Arm. Hope this helps.
Jeanne Riley is offline  
 
Page generated in 0.02225 seconds with 8 queries