View Single Post
Old April 2, 2020, 09:18 AM   #1
ECM4
Member
 
Join Date: February 18, 2019
Location: West Virginia
Posts: 54
Red dot on AR PCC

I put a Vortex Venom red dot on my 9mm AR PCC. I have a 3/4 inch riser that my red dot in mounted on. My elevation is maxed. Has anyone ran into this problem?I’m still 3-4 inches low at 30 yards. My riser doesn’t have any MOA built in. I might buy a rail with some MOA built in to raise the point of impact but I’m starting to wonder if something is wrong with my red dot. I started out about 15 inches low but after maxing the elevation I could only get it to 3-4 inches low.
ECM4 is offline  
 
Page generated in 0.02858 seconds with 8 queries