View Single Post
Old October 19, 2018, 06:09 AM   #24
jpx2rk
Senior Member
 
Join Date: December 29, 2015
Posts: 189
I tried a Mighty Armory de-capping/swage set up and like it alot. Once you set the die up, deprimes with ease, and then just swap out the depriming pin for the swage pin, install the swaging nub on the ram and slip the cap over the nub, go to town.

No adjustments on the die or set up other than that. No adjustment for different brands of crimped brass needed as I had read several comments about having to adjust the swaging die for different brands of brass. I do have a few that need a bit of attention with a Hornady crimp tool but I wait until I have trouble priming that/those cases.
jpx2rk is offline  
 
Page generated in 0.02923 seconds with 8 queries