View Single Post
Old October 18, 2018, 05:49 PM   #16
Senior Member
Join Date: March 20, 2014
Location: Kinda near Phoenix, AZ
Posts: 1,048
Lyman pocket reamer bit chucked into cordless drill. About seven-to-ten seconds I guess per piece. Trick is to let the drill do all the work; trying to run the drill at top speed while trying to jam the brass onto bit just makes the brass really hot and wears out your fingers. If you do it gently/slowly, you can feel the bit "bottom out" and you know you're done with that one and on to the next piece.
Rangerrich99 is offline  
Page generated in 0.02872 seconds with 8 queries