So, is the 8 round follower just a shorter version of the 7 round follower?
It would appear possible to cut down the 7 round follower so that it can travel further towards the floorplate, thus allowing 8 rounds. The portion to be cut would be the long side that travels down the spine of the mag as the rounds are loaded. Test fitting with 8 rounds with the spring out and the florrplate off indicates exactly 1/8th inch should be removed.
Would someone out there mind comparing the 7 and 8 round followers to see what the difference is?
------------------
“The whole of the Bill (of Rights) is a declaration of the right of the people at large or considered as individuals. ... It establishes some rights of the individual as unalienable and which consequently, no majority has a right to deprive them of.” -Alexander Addison, 1789
[This message has been edited by deanf (edited July 19, 1999).]
[This message has been edited by deanf (edited July 19, 1999).]
|