The Firing Line Forums - View Single Post - Is deburring the flash hole really helpful?

Wyoredman · May 7, 2013, 05:44 PM

I use my Lyman flash hole de-burring tool to get the tumbling media out of the flash holes. I like to run the brass back through corn cob media after sizing to remove any lingering case lube, and invariably, some of the media gets lodged in the flash holes. So the Lyman tool to the rescue, clean flash holes that also happen to be de-burred!

Load on.

May 7, 2013, 05:44 PM	#12
Wyoredman Senior Member Join Date: September 6, 2011 Location: Wyoming Posts: 1,350	I use my Lyman flash hole de-burring tool to get the tumbling media out of the flash holes. I like to run the brass back through corn cob media after sizing to remove any lingering case lube, and invariably, some of the media gets lodged in the flash holes. So the Lyman tool to the rescue, clean flash holes that also happen to be de-burred! Load on. __________________ Go Pokes! Go Rams!