Thank you both.
I bought a digital micrometer today to do precise measurements, here is hoping I fall within those saami specs.
I only intend to be within spec, not do anything exotic.b What I did with approximately 100 cases is deburr and chamber with an RCBS hand tool, and I want to make sure I was not too zealous and make my shells fall out of spec.
I was also concerned with pressure problems (if any) that might show up if the cases are perhaps a hundredth out of spec (too short)?
Thanks again all!
....andI of course acknowledge my noob-ness in regard to not testing case length prior to deburring and chamfering.
Stupid, I know.
Unclenick---(and any others)
to what degree should my brass be uniform for purposes of plinking reloading?
Saami specs most permissible for pressure/safety purposes?
Also, what toll would you recommedn for trimming. I am looking for low budget/accurate. (I typically want my cake and to eat it too).
thanks.
__________________
"...and which is worst of all, continual fear and danger of violent death, and the life of man, solitary, poor, nasty, brutish, and short."-Thomas Hobbes, Leviathan
...What he meant to add was, "unless, of course, all responsible citizens are armed to the teeth."
Last edited by Unclenick; January 8, 2013 at 09:42 AM.
|