Well I took it apart and sure enough it does have a hole in the center of the plug which contacts the ogive. The edges of this hole are quite sharp and there was a small build up of lead around the Outside edge. Which makes me believe my cartridges aren't ascending squarely into the die. The more I think about it I do recall ocasionnaly I would feel a slight rub as I was seating if you will and inspection of the finished cartridges shows that the damage done to the tips are all on the sides of them. So I'm ocassionaly shaving a tip while seating. Hmmm. I had to move my set up inside temporarily and its not the sturdiest bench in the world. Could this be press play?
|