View Single Post
Old May 12, 2012, 08:56 PM   #1
unclekuster
Member
 
Join Date: May 12, 2012
Posts: 29
22 hornet flashole

Been sending 32g Hornady V-max rounds down range to feed the fatbellies. Now it's time to reload, and I got most of my cases sized and trimmed to length, but the flash hole is so small the de-capping pin keeps getting stuck inside the case. The only flash hole uniformer I have been able to find is the Lyman version. Which brings me to my question: Will that make the flash hole too big ? The little drill bit on the end of the uniformer sure seem like its at least twice the size of the original flash hole. Will this damage the Brass ? Should I skip this step ? Am I asking the right questions ?
unclekuster is offline  
 
Page generated in 0.02395 seconds with 8 queries