View Single Post
Old May 1, 2006, 07:59 PM   #7
Lazy D
Senior Member
 
Join Date: December 11, 2004
Location: Indian Territory
Posts: 192
Not a problem

If you already have a "Cylinder Bore" it wont be a problem. I charge $75.00 to install Rem chokes. If you have a dial caliper and can measure the ID and the OD of the barrel I can tell you for sure. If it is over .735 ID it can't be done. You also need a minimum of .015 wall thinkness after it is reamed to .795. Thin wall chokes can be used if needed.
Contact your local gunsmith he can check it all out for you. Prices will vary $75.00 up to $150.00. Good Luck
__________________
"Fast is Fine but accuracy is final.".....Wyatt Earp.
Lazy D is offline  
 
Page generated in 0.02217 seconds with 8 queries