The Firing Line Forums - View Single Post

Sphawley · January 10, 2013, 07:10 PM

Working on my first batch of reloads, Im using some brass that needs to be trimmed already. Starting off with the full cycle you could say...

Im struggling to get my Lyman universal case trimmer to the correct length for .308 of 2.015, initially I slowly trimmed a case to this correct length and then set it in there and then pushed the cutter up against it and set the set screws to hold. However this process didnt exactly work out for some reason.

What am I doing wrong is there a better way to approach this? How do you get the cutter set correctly?

January 10, 2013, 07:10 PM	#1
Sphawley Senior Member Join Date: June 9, 2010 Location: Las Vegas Posts: 272	Lyman Universal Case Trimmer Working on my first batch of reloads, Im using some brass that needs to be trimmed already. Starting off with the full cycle you could say... Im struggling to get my Lyman universal case trimmer to the correct length for .308 of 2.015, initially I slowly trimmed a case to this correct length and then set it in there and then pushed the cutter up against it and set the set screws to hold. However this process didnt exactly work out for some reason. What am I doing wrong is there a better way to approach this? How do you get the cutter set correctly? __________________ If guns kill people, then pencils misspell words, cars make people drive drunk, and spoons made Rosie O' Donnell fat!