View Single Post
Old July 23, 2021, 11:32 AM   #15
Senior Member
Join Date: March 1, 2009
Posts: 4,232
It's not the force needed to seat bullets that's important for accuracy. It's the force needed to push it out of the case neck.
don't you suppose there may be a correlation there

Especially when the case mouth inside edge scrapes off jacket metal unbalancing the bullet before it is shot. How many folks round off that inside edge after deburring it?
it's called chamfering, and something I do every loading. I also use powdered graphite on every round

In my tests, it takes a little less force to push bullets out.
did you use something like this?

to me this would be the minimum for getting accurate results in a push/pull test
“How do I get to the next level?” Well, you get to the next level by being the first one on the range and the last one to leave.” – Jerry Miculek
hounddawg is offline  
Page generated in 0.02051 seconds with 8 queries