Thread: S&W .38 Mod 10
View Single Post
Old July 15, 2021, 07:05 AM   #10
4V50 Gary
Join Date: November 2, 1998
Location: Colorado
Posts: 21,592
Oh gawd! I had an old victory model and had to make a new cylinder center pin. The original was JB Welded up to length and so a new one had to be turned on the lathe. I learned that when I went to file the top to smooth it out. Too much came off with one pass of a fine tooth file.

Good luck in getting that longer ejector rod. Keep shopping.
Vigilantibus et non dormientibus jura subveniunt. Molon Labe!
4V50 Gary is offline  
Page generated in 0.02009 seconds with 8 queries