View Single Post
Old December 4, 2019, 06:49 PM   #3
Nathan
Senior Member
 
Join Date: July 1, 2001
Posts: 6,285
You have to determine what is stopping it.

If I read you right, the bullet is going up the feed ramp.....it almost sounds like the issue is happening at the rear of the case. After the bullet starts up the feed ramp, the mag should release the case head. The release should be able to power its way under the extractor. Sometimes magazines hold on too long(out of spec) or the extractor is too tight.

I’m not sure what 10mm build means. Are you building an 80% Glock type frame and attaching to a Glock type slide?
Nathan is offline  
 
Page generated in 0.02908 seconds with 8 queries