The Firing Line Forums - View Single Post

ECM4 · April 2, 2020, 09:18 AM

I put a Vortex Venom red dot on my 9mm AR PCC. I have a 3/4 inch riser that my red dot in mounted on. My elevation is maxed. Has anyone ran into this problem?I’m still 3-4 inches low at 30 yards. My riser doesn’t have any MOA built in. I might buy a rail with some MOA built in to raise the point of impact but I’m starting to wonder if something is wrong with my red dot. I started out about 15 inches low but after maxing the elevation I could only get it to 3-4 inches low.

April 2, 2020, 09:18 AM	#1
ECM4 Member Join Date: February 18, 2019 Location: West Virginia Posts: 55	Red dot on AR PCC I put a Vortex Venom red dot on my 9mm AR PCC. I have a 3/4 inch riser that my red dot in mounted on. My elevation is maxed. Has anyone ran into this problem?I’m still 3-4 inches low at 30 yards. My riser doesn’t have any MOA built in. I might buy a rail with some MOA built in to raise the point of impact but I’m starting to wonder if something is wrong with my red dot. I started out about 15 inches low but after maxing the elevation I could only get it to 3-4 inches low.