View Single Post
Old January 9, 2013, 12:06 PM   #6
Junior Member
Join Date: January 8, 2013
Posts: 3
I've tried cleaning with the chamber brush that came with the COLT. Used it with a number of solvents / CLP / Power-Blast / WD-40.

If it is contamination from using the steel ammo rather than a 'final step' left out at the COLT factory, I should be able to clean it myself. (?)

It's hard to believe that COLT and their QC would allow a new LE6920 to leave the factory with something obvious like this.

I attepnted to email photos to COLT at the address shown on their website [email protected] but it bouced back to me this morning as an invalid address.

Does anyone know of a new, valid email address for COLT?

Any suggestions on removing the contamination? Someone mentioned FLITZ metal polish / 0000 Steel Wool ?
SteveSS is offline  
Page generated in 0.03125 seconds with 8 queries