The Firing Line Forums - View Single Post - Pre-measuring your loads. Bad idea?

m&p45acp10+1 · December 16, 2012, 07:27 AM

James any type of tray will work just find a box it will fit in. Oh and for a block less likely to tip you can glue a thick sponge to a piece of wood. cut holes in the sponge for the cases to fit through. I did this for my fly tying solvents, and head cements. It holds them up keeping them from tipping over.

I am sure a car washing, or dish washing sponge cost less 5 Euros.

December 16, 2012, 07:27 AM	#40
m&p45acp10+1 Senior Member Join Date: May 3, 2009 Location: Central Texas Posts: 3,930	James any type of tray will work just find a box it will fit in. Oh and for a block less likely to tip you can glue a thick sponge to a piece of wood. cut holes in the sponge for the cases to fit through. I did this for my fly tying solvents, and head cements. It holds them up keeping them from tipping over. I am sure a car washing, or dish washing sponge cost less 5 Euros. __________________ No matter how many times you do it and nothing happens it only takes something going wrong one time to kill you.