The Firing Line Forums - View Single Post - scope base screw broken off in receiver, need help..

edward5759 · August 14, 2010, 05:10 AM

I've done them on a mill and a drill press.
every time i've finished I run a bottoming tap in to clean up.

Ed

August 14, 2010, 05:10 AM	#14
edward5759 Senior Member Join Date: September 15, 2009 Location: Phoenix, AZ. 30 miles from water, two feet from Hell. Posts: 355	I've done them on a mill and a drill press. every time i've finished I run a bottoming tap in to clean up. Ed