View Single Post
Old March 30, 2006, 01:06 PM   #5
Leftoverdj
Senior Member
 
Join Date: October 15, 2004
Posts: 934
There are a couple of different types of press mounted bullet pullers. The kind in which the bullet is forced through a hole in a spring plate, then retracted, may mar bullets badly. I've never used the collet type, but understand that it requires a straight section of the bullet to be exposed. Both are caliber specific while the inertial puller is close to universal. The inertial puller requires a very solid wood surface to strike against. It'll break on steel or concrete and any spring in the struck surface will lessen the effectiveness. I use a section of oak log about 15" in diameter and height.

It's gonna be a PITA no matter how you do it.
Leftoverdj is offline  
 
Page generated in 0.03242 seconds with 8 queries